Search found 10 matches

Hello Jim,
there have been sets from Kolbenschmidt.
But the Chinese parts will be much cheaper.

http://www.gaenssle.de/Englisch/FrmSetE03.htm

Daniel

If you grind the crank 0,25mm you would have to nitride it again.

To get back the original hardenes.

Here are some Rod Bearings.

https://www.ebay.de/sch/m.html?_odkw=&_ssn=tongtong-motor& ...

The cover with M5 screws is upto serial number: 2117865

Look here.

https://www.cmsnl.com/honda-cb750f-750-super-sport-1980-a-usa_model7241/partslist/E++09.html#.XbP1DdXgpPb

Regards,
Daniel

The Hornet is a nice Bike.
But not the fastest one,a friend sold his Hornet because he could not follow my CBX on the Highway (germany without Speed limit).

He bought a CBR 1000rr.

Regards,
Da ...

CBX World is online,
but last post in the moment is December 2016 Confused

Hello Jim,
the GSXR 1100 was only build till 1996

Here is a list with some fork sizes.

http://www.fighters-forum.de/viewtopic.php?f=32&t=129279

Regards,
Daniel

Hello,
is it possible to use the low pressure oilpumpe side for cooling the alternator?
From oilcooler to alternator cover (front) and from the back side to the oil pan.
But I think this will only ...

I think the problem is the missing centering Ring.
It is not possible to center the Clutch only with the 6 Screws.
When the 6 holes are bored and you put the Screws in you still have clearence.
The ...

@Jim
the Rods look like A-Beam Carrillo Rods.

Daniel

Hello,
for Shim under you could use Suzuki TL 1000 Retainer (aluminium) with GSX 1100 Valve Keepers and the extreme light but shorter TL 1000 Buckets or the MV Agusta F4 Buckets (same size as CB but ...