Search found 299 matches

It would be handy to post a complete list on the forum.

Thanks guys!

Is there a list that’s been posted anywhere of the stock chamber volumes? I’ve been trying to find out what the stock cb1100f cylinder head chamber volume is and I can’t find it anywhere. I’ve searche ...

Looks solid!

Holy crap. Welcome back!

I found bearings that would work years ago (can't remember if it was bandit or Hayabusa bearings, something like that. The issue I ran into was was width across the bearing and Tang location. Not a na ...

Both of those possibilities are ver interesting!

I could possibly 3D print one from nylon. I would need the used one to make a CAD model.

Cheers
Nich

^ Can't say I blame you. I looked for years, never found a replacement. Custom sounds interesting, but expensive.

Right! However the stock bearings are fairly expensive anyway and sometimes custom ...

You’re not missing anything. I don’t want to use no name Chinese bearings unless that’s the only option. I would prefer to use reputable race quality bearings.

what about King Engine bearings, do they make or can make anything?

King, ACL, Mahle/Clevite are all possibilities for custom manufacture. I don’t think they already make bearings for these engines ...

One thing to bear in mind is the supplied Honda bearings are not a constant thickness around the radius of the shell
This was disgussed here many years ago

I have measured recently purchased and a ...

If you grind the crank 0,25mm you would have to nitride it again.

To get back the original hardenes.

Here are some Rod Bearings.

https://www.ebay.de/sch/m.html?_odkw=&_ssn=tongtong-motor& ...

Hi Nich,

perhaps,

Thanks for the links. I’ll check them out.

Normally you weld the bad crank journal and machine it back to spec! Are all of your crank journals fubared?

Like Jim said while this is possible it’s not very realistic. It would possibly be cheap ...

I would like to know the answer to this myself as far as the hardness goes.

I remember a thread that Sonicrete had looked and looked for bearings but no luck. If you go with the thickest bearing. ...

Wondering if anyone knows of a source for undersized bearings so a crank with bad main journals could be ground .25mm under. I’m also curious how deep the hardness is. If the journals are ground would ...

So good

GO NATHAN GO!

I general I prefer Hall effect to VR sensors as the VR produce more electrical noise. It might never cause a problem on an ignition only bike but can definitely cause problems on an efi equipped engin ...

Let me know would you please.

I told Nich for you already Laughing

Haha except I don’t order parts for Greg. He orders his own and they show up at my door!

I’ll glady pass it on though Smile

Is that a twist tie on the chain guard rubber? 😉

Hi Nich,
Yes I used SS wire to hold the chain slider on. The 750 and 900 swingarms don’t have the guard and I hate hearing the chain hit th ...

Is that a twist tie on the chain guard rubber? 😉

When hot starts are difficult, have you tried pushing the starter button with the kill switch turned to off and then flipping the switch to on while cranking? Sometimes that helps and it’s much easier ...

Thanks for taking the plunge and reporting back!

When hot starts are difficult, have you tried pushing the starter button with the kill switch turned to off and then flipping the switch to on while ...

Name names, don’t tar every seller here with a broad brush. I have been on both sides of a sale and have never been treated improperly so if the seller does not want to make things right they should ...

Take the head to your local machine shop. They should already have all the tooling and experience necessary to install a timesert for you.

Cheers!
Nich

Hp sells. I see it all the time in my line of work. Guys spend huge amounts of money on their engine and twice that on the paint job and wheels and have no money left for the chassis. They then wonder ...

Got mine! Thanks again Matt!